2 Day Hands On J2534 and OE Domestic and Asian Programming Training Event
October 16 @ 8:00 am - October 17 @ 5:00 pm$1500
This 2 day hands on J2534 class is designed to have some advanced and unconventional information to satisfy even the most seasoned of module programming techs! We will cover the use of aftermarket tooling and other options to use a USED module when FORD, GM and Nissan block this function in the factory tooling. BUT! We will cover all information needed to take a technician that has never flashed a module and prepare them to successfully flash the most common vehicles, as well as arm them with the troubleshooting skills to tackle even the peskiest of module programming scenarios.
We will cover all the equipment and software requirements of today. This J2534 class will prepare you for GM, Ford, Chrysler, Nissan, Toyota, Honda, Mazda, Hyundai and Kia vehicles. We will cover some best practices, workarounds, and the limitations of the J2534 platform so we can cover the need in some instances for OE equipment. This class will also touch on “Right to Repair” information and how it pertains to module flashing and OE software in the field. So put your J-Box where your mouth is and buckle up for a complete J2534 2 day hands on crash course!
The event is held in Tulsa Oklahoma at our fully air conditioned shop, it is recommended that you bring your Laptop/s that you use for programming as well as your J2534 device.
The cost of class covers Friday and Saturdays hotel, breakfast and lunch for each day of class, Saturdays dinner is cover as well, we will go out as a group. The book for class is also included in the cost.
More information about parking and hotel will be emailed after registration.
Make sure to send PHONE NUMBER AND EMAIL during registration.